ar71xx: use the new ar7240 switch driver on the DIR-600-A1 as well (fixes #7563)

[openwrt/svn-archive/archive.git] / target / linux / ar71xx / files / arch / mips / ar71xx / mach-ap83.c

diff --git a/target/linux/ar71xx/files/arch/mips/ar71xx/mach-ap83.c b/target/linux/ar71xx/files/arch/mips/ar71xx/mach-ap83.c
index cd4746ba7004bc66175e0a3143b73753fc086d40..8417b75396e1c3b83c4093d57b9333286b1f3c32 100644 (file)
--- a/target/linux/ar71xx/files/arch/mips/ar71xx/mach-ap83.c
+++ b/target/linux/ar71xx/files/arch/mips/ar71xx/mach-ap83.c
@@ -119,15 +119,15 @@ static struct gpio_button ap83_gpio_buttons[] __initdata = {
        {
                .desc           = "soft_reset",
                .type           = EV_KEY,
-               .code           = BTN_0,
-               .threshold      = 5,
+               .code           = KEY_RESTART,
+               .threshold      = 3,
                .gpio           = AP83_GPIO_BTN_RESET,
                .active_low     = 1,
        } , {
                .desc           = "jumpstart",
                .type           = EV_KEY,
-               .code           = BTN_1,
-               .threshold      = 5,
+               .code           = KEY_WPS_BUTTON,
+               .threshold      = 3,
                .gpio           = AP83_GPIO_BTN_JUMPSTART,
                .active_low     = 1,
        }
@@ -196,17 +196,16 @@ static void __init ap83_generic_setup(void)
 {
        u8 *eeprom = (u8 *) KSEG1ADDR(0x1fff1000);
 
-       ar71xx_set_mac_base(eeprom);
-
        ar71xx_add_device_mdio(0xfffffffe);
 
+       ar71xx_init_mac(ar71xx_eth0_data.mac_addr, eeprom, 0);
        ar71xx_eth0_data.phy_if_mode = PHY_INTERFACE_MODE_RGMII;
        ar71xx_eth0_data.phy_mask = 0x1;
 
        ar71xx_add_device_eth(0);
 
+       ar71xx_init_mac(ar71xx_eth1_data.mac_addr, eeprom, 1);
        ar71xx_eth1_data.phy_if_mode = PHY_INTERFACE_MODE_RGMII;
-       ar71xx_eth1_data.phy_mask = 0x0;
        ar71xx_eth1_data.speed = SPEED_1000;
        ar71xx_eth1_data.duplex = DUPLEX_FULL;