ramips: Add switch setup to uci network defaults

Add switch setup to uci network defaults.

The 'lan' attribute is used to decide into which vlan to put the
port.
Currently 'disable' is never set, but the intention is to use this
for devices like the 8devices Carambola, which only has two ports
hooked up to the SoC.

Signed-off-by: Tobias Diedrich <ranma+openwrt@tdiedrich.de>
SVN-Revision: 33300

diff --git a/target/linux/ramips/base-files/etc/uci-defaults/network b/target/linux/ramips/base-files/etc/uci-defaults/network
index 106a61352c1ace7f3564bf111839df6c0e2a315a..6542d021eecb17f63a14814b64051c1a6516598e 100755 (executable)
--- a/target/linux/ramips/base-files/etc/uci-defaults/network
+++ b/target/linux/ramips/base-files/etc/uci-defaults/network
@@ -9,6 +9,31 @@ if [ ! -x /usr/sbin/maccalc ]; then
        return
 fi
 
        return
 fi
 

+ramips_setup_rt3x5x_vlans()
+{
+       if [ ! -x /sbin/swconfig ]; then
+               # legacy default
+               ucidef_set_interfaces_lan_wan "eth0.1" "eth0.2"
+               return
+       fi
+       local wanports=""
+       local lanports=""
+       for port in 5 4 3 2 1 0; do
+               if [ `swconfig dev rt305x port $port get disable` = "1" ]; then
+                       continue
+               fi
+               if [ `swconfig dev rt305x port $port get lan` = "0" ]; then
+                       wanports="$port $wanports"
+               else
+                       lanports="$port $lanports"
+               fi
+       done
+       ucidef_set_interfaces_lan_wan "eth0.1" "eth0.2"
+       ucidef_add_switch "rt305x" "1" "1"
+       ucidef_add_switch_vlan "rt305x" "1" "$lanports 6t"
+       ucidef_add_switch_vlan "rt305x" "2" "$wanports 6t"
+}
+

 ramips_setup_interfaces()
 {
        local board="$1"
 ramips_setup_interfaces()
 {
        local board="$1"


@@ -74,7 +99,7 @@ ramips_setup_interfaces()
        *)
                RT3X5X=`cat /proc/cpuinfo | grep RT3.5`
                if [ -n "${RT3X5X}" ]; then
        *)
                RT3X5X=`cat /proc/cpuinfo | grep RT3.5`
                if [ -n "${RT3X5X}" ]; then

-                       ucidef_set_interfaces_lan_wan "eth0.1" "eth0.2"
+                       ramips_setup_rt3x5x_vlans

                else
                        ucidef_set_interfaces_lan_wan "eth0" "eth1"
                fi
                else
                        ucidef_set_interfaces_lan_wan "eth0" "eth1"
                fi