staging/lynxis/target, branch reboot

ar71xx: Add support for the OMYlink OMY-G1

2016-04-26T11:44:36Z

https://wiki.openwrt.org/toh/omylink/omy-g1 http://www.omylink.com/ Signed-off-by: L. D. Pinney SVN-Revision: 49258

zynq: Add Zybo device support

2016-04-26T11:44:29Z

Signed-off-by: Jason Wu SVN-Revision: 49257

Zynq: Add Zedboard device support

2016-04-26T11:44:26Z

Tested-by: Joe Zhang Signed-off-by: Jason Wu SVN-Revision: 49256

zynq: Remove rdinit patch

2016-04-26T11:44:22Z

This is not required as long as CONFIG_TARGET_INIT_CMD is correctly configured. Signed-off-by: Jason Wu SVN-Revision: 49255

lantiq: use dwc2 by default on all ar9 boards

2016-04-26T11:44:17Z

The dwc2 USB driver now works on Lantiq ar9, but the default is still ltq-hcd-ar9. This patch switches to dwc2 by default. v2: all ar9 boards (v1 was just for BTHOMEHUBV3A and WBMR) Signed-off-by: Ben Mulvihill SVN-Revision: 49254

lantiq: install uboot-envtools by default on BTHOMEHUBV3A

2016-04-26T11:44:13Z

The only way to access the u-boot console on the BTHOMEHUBV3A is by soldering a serial console onto some really tiny pads. To enable installation without soldering it would be helpful to be able to modify the uboot environment from within the ramdisk image used as part of the installation process. Signed-off-by: Ben Mulvihill SVN-Revision: 49253

lantiq: remove read-only flag on two partitions on BTHOMEHUBV3A

2016-04-26T11:44:03Z

Remove read-only flag on two partitions on BTHOMEHUBV3A: uboot-config - otherwise fw_setenv command cannot be used. ath9k-cal - so that ath9k calibration data can be copied to the partition on a newly installed board. Signed-off-by: Ben Mulvihill SVN-Revision: 49250

cns3xxx: set both MPS 'and' MRSS to 128

2016-04-26T11:44:00Z

Fixes some DMA issues with this platform. Because this isn't currently accepted, and can potentially disrupt other platforms (as read in commit log), I will leave this cns3xxx specific. Original Patch: https://patchwork.ozlabs.org/patch/600024/ Signed-off-by: Pushpal Sidhu SVN-Revision: 49249

cns3xxx: backport pci fix for cns3xxx_write_config

2016-04-26T11:43:57Z

Fix is required to properly set pci config bits. Original Patch: https://patchwork.ozlabs.org/patch/596170/ Signed-off-by: Pushpal Sidhu SVN-Revision: 49248

ramips: Add support for the Netgear WNDR3700v5

2016-04-26T11:43:53Z

https://wiki.openwrt.org/toh/netgear/wndr3700 wndr3700v5 uses the single-core dual thread MediaTek MT7621S SoC. Signed-off-by: L. D. Pinney SVN-Revision: 49247