staging/lynxis/omap/target, branch master

omap: rework image generation and profiles

2017-04-21T17:44:19Z

Migrate to new image generation and introduce sdcard generation (based on sunxi). Profile now generated via image/Makefile instead of profiles/ directory. Signed-off-by: Alexander Couzens

omap: correct CPU_TYPE: omaps are cortext-a8

2017-04-21T16:18:19Z

Signed-off-by: Alexander Couzens

omap/Kconfig: enable SMP

2017-04-21T16:18:15Z

Pandaboard has a multi-core omap. Signed-off-by: Alexander Couzens

brcm2708: disable CONFIG_BCM2835_THERMAL by default

2017-04-15T06:24:42Z

This fixes: Thermal sensors on bcm2835 SoC (BCM2835_THERMAL) [N/m/y/?] (NEW) aborted! This symbol depends on ARCH_BCM2835 so it should be OK to disable it at brcm2708 target only. Fixes: 7d32caa61fb0 ("brcm2708: backport upstream sdhost controller driver") Signed-off-by: Rafał Miłecki

kernel: backport Broadcom thermal drivers

2017-04-14T20:57:47Z

This includes driver for Northstar and for Raspberry Pi. Signed-off-by: Rafał Miłecki

ramips: really drop the rt-n56u factory image

2017-04-13T17:22:23Z

Remove the stale reference to the factory image. Signed-off-by: Mathias Kresin

ar71xx: fix ath9k default LED changes fallout

2017-04-13T06:18:57Z

Since 192f0a3db859 ("ath9k: unset the default LED pin if used by platform leds") the default ath9k wireless LED is not set as soon as any pin of the ath ath9k gpio controller is used. All touched boards have leds defined which are using the gpio pins exposed by the ath9k driver but rely on a default set wireless led trigger. Add the wireless leds were missing and setup the wireless phy trigger in userspace. Signed-off-by: Russell Senior Signed-off-by: Mathias Kresin

ramips: fix Netgear R6220 package selection

2017-04-13T06:18:57Z

The Netgear R6220 requires the kmod-usb3 package and misses kmod-usb-ledtrig-usbport package to setup the configured usb led trigger. Drop the already target selected kmod-mt76. Fixes: FS#686 Fixes: 38bee61dab02 ("ramips: add support for Netgear R6220") Signed-off-by: Mathias Kresin

ramips: add RP-N53 pcie wireless eeprom

2017-04-13T06:18:57Z

Fix the PCIe 5GHz wireless by using the on flash eeprom/caldata. Disable the 2.4GHz band as this band has no antennas attached but is enabled in the eeprom/caldata. Fixes: FS#691 Signed-off-by: Mathias Kresin

ramips: fix WHR-600D eeprom dt property

2017-04-13T06:18:57Z

Fix the PCIe 5GHz wireless by using the ralink mtd-eeprom property as this board have a RT5592 and uses the rt2x00 driver. The mediathek device tree bindings do not work here. Fixes: FS#691 Fixes: d8dd207ea6f2 ("ramips: use the ralink,mtd-eeprom device tree property") Signed-off-by: Mathias Kresin