staging/xback, branch reboot

ar71xx: Add support for the OMYlink OMY-G1

2016-04-26T11:44:36Z

https://wiki.openwrt.org/toh/omylink/omy-g1 http://www.omylink.com/ Signed-off-by: L. D. Pinney SVN-Revision: 49258

zynq: Add Zybo device support

2016-04-26T11:44:29Z

Signed-off-by: Jason Wu SVN-Revision: 49257

Zynq: Add Zedboard device support

2016-04-26T11:44:26Z

Tested-by: Joe Zhang Signed-off-by: Jason Wu SVN-Revision: 49256

zynq: Remove rdinit patch

2016-04-26T11:44:22Z

This is not required as long as CONFIG_TARGET_INIT_CMD is correctly configured. Signed-off-by: Jason Wu SVN-Revision: 49255

lantiq: use dwc2 by default on all ar9 boards

2016-04-26T11:44:17Z

The dwc2 USB driver now works on Lantiq ar9, but the default is still ltq-hcd-ar9. This patch switches to dwc2 by default. v2: all ar9 boards (v1 was just for BTHOMEHUBV3A and WBMR) Signed-off-by: Ben Mulvihill SVN-Revision: 49254

lantiq: install uboot-envtools by default on BTHOMEHUBV3A

2016-04-26T11:44:13Z

The only way to access the u-boot console on the BTHOMEHUBV3A is by soldering a serial console onto some really tiny pads. To enable installation without soldering it would be helpful to be able to modify the uboot environment from within the ramdisk image used as part of the installation process. Signed-off-by: Ben Mulvihill SVN-Revision: 49253

dnsmasq: run as dedicated UID/GID

2016-04-26T11:44:10Z

Running dnsmasq in a dedicated user/group allows matching its outgoing traffic more easily using iptables' owner match. Add UID/GID to the package metadata and append the user/group parameters to the init script. Signed-off-by: Daniel Golle SVN-Revision: 49252

mac80211: ath9k: add GPIO support for AR9280 chip

2016-04-26T11:44:07Z

Enable access to GPIO on Atheros wireless chip AR9280. Support for 9280 is added to existing 9285/9287 subsystem because these 3 chips differ only in number of GPIO pins. Signed-off-by: Michal Cieslakiewicz SVN-Revision: 49251

lantiq: remove read-only flag on two partitions on BTHOMEHUBV3A

2016-04-26T11:44:03Z

Remove read-only flag on two partitions on BTHOMEHUBV3A: uboot-config - otherwise fw_setenv command cannot be used. ath9k-cal - so that ath9k calibration data can be copied to the partition on a newly installed board. Signed-off-by: Ben Mulvihill SVN-Revision: 49250

cns3xxx: set both MPS 'and' MRSS to 128

2016-04-26T11:44:00Z

Fixes some DMA issues with this platform. Because this isn't currently accepted, and can potentially disrupt other platforms (as read in commit log), I will leave this cns3xxx specific. Original Patch: https://patchwork.ozlabs.org/patch/600024/ Signed-off-by: Pushpal Sidhu SVN-Revision: 49249