bcm63xx/u-boot/board/mscc/jr2, branch masterBroadcom-s U-Boothttps://git.openwrt.org/project/bcm63xx/u-boot/atom?h=master2019-04-12T15:32:51Zboard: mscc: jr2: Update MSCC Jaguar2 boards2019-04-12T15:32:51ZHoratiu Vultur2019-04-03T17:54:46Zurn:sha1:6aa50ae22c63e2b509bad2a815c12946b8a9aaf8
In Jaguar2 SoC family there are 3 different pcb. Each of this needs
to configure the phys in different ways. Therefore implement the
function board_phy_config and based on pcb configure them accordingly.
Signed-off-by: Horatiu Vultur <horatiu.vultur@microchip.com>
MSCC: Fix Jaguar2 board detection.2019-02-01T13:09:31ZHoratiu Vultur2019-01-29T09:58:34Zurn:sha1:78b543141090b7c35a64418157b5194588a9f955
When power cycle the Jaguar2 boards, it couldn't read the
phys, therefore it always deduce that the board type is
pcb111.
Add a small delay after setting the gpio pins, fix the
issue.
Signed-off-by: Horatiu Vultur <horatiu.vultur@microchip.com>
MSCC: Jaguar2 enable debug uart2019-02-01T13:08:54ZHoratiu Vultur2019-01-29T09:50:16Zurn:sha1:45988b123cf40bb651d7c48e913b010a8e255643
Enable debug uart for Jaguar2 SoC family.
Signed-off-by: Horatiu Vultur <horatiu.vultur@microchip.com>
MSCC: Add board support for Jaguar2 SOC family2019-01-16T12:56:43ZHoratiu Vultur2019-01-12T17:57:00Zurn:sha1:c75c908316983eb729ce7e6449959dcabd58413b
Add board support and configuration for Jaguar2 SOC family.
The detection of the board type in this family is based on the phy ids.
Signed-off-by: Horatiu Vultur <horatiu.vultur@microchip.com>