bcm63xx/u-boot/configs/sagem_f@st1704_ram_defconfig, branch master

configs: Resync with savedefconfig

2019-04-30T01:41:40Z

Rsync all defconfig files using moveconfig.py Signed-off-by: Tom Rini

MIPS: bmips: switch to CONFIG_OF_SEPARATE

2019-01-16T12:59:46Z

Fix the Kconfig warning to not use CONFIG_OF_EMBED in defconfigs. Based on https://patchwork.ozlabs.org/patch/1019791/ Signed-off-by: Álvaro Fernández Rojas Signed-off-by: Daniel Schwierzeck

bmips: enable f@st1704 enet support

2018-12-19T14:23:01Z

Signed-off-by: Álvaro Fernández Rojas

configs: Resync with savedefconfig

2018-09-03T19:26:12Z

Rsync all defconfig files using moveconfig.py Signed-off-by: Tom Rini

configs: Migrate CONFIG_NR_DRAM_BANKS

2018-08-16T20:45:02Z

We have the following cases: - CONFIG_NR_DRAM_BANKS was defined, migrate normally - CONFIG_NR_DRAM_BANKS_MAX was defined and then used for CONFIG_NR_DRAM_BANKS after a check, just migrate it over now. - CONFIG_NR_DRAM_BANKS was very oddly defined on p2771-0000-* (to 1024 + 2), set this to 8. Signed-off-by: Tom Rini

Convert CONFIG_SPI to Kconfig

2018-04-27T18:54:11Z

This converts the following to Kconfig: CONFIG_SPI This partly involves updating code that assumes that CONFIG_SPI implies things that are specific to the MPC8xx SPI driver. For now, just update the CONFIG tests. This also involves reworking the default for CONFIG_SYS_DEF_EEPROM_ADDR so that we don't set it when we cannot make a reasonable default, as it does not cause any compile failures. Signed-off-by: Adam Ford Signed-off-by: Tom Rini

mips: bmips: select OF_EMBED for all boards

2018-03-21T22:23:13Z

Signed-off-by: Álvaro Fernández Rojas

Kconfig: cmd: Make networking command dependent on NET

2018-02-27T21:25:30Z

Enable networking command only when NET is enabled. And remove selecting NET for CMD_NET Signed-off-by: Michal Simek Signed-off-by: Tom Rini

cmd: Make CONFIG_CMD_FPGA depend on CONFIG_FPGA

2018-02-06T01:58:11Z

cmd/Makefile has: ifdef CONFIG_FPGA obj-$(CONFIG_CMD_FPGA) += fpga.o endif which means that if CONFIG_FPGA is not set, CONFIG_CMD_FPGA silently does nothing. Let's remove that Makefile conditional and instead express this equivalent dependency in Kconfig, so a lot of redundant # CONFIG_CMD_FPGA is not set can be removed from board defconfigs that don't actually have an FPGA. Signed-off-by: Tuomas Tynkkynen

mips: bmips: enable the SPI flash on the Sagem F@ST1704

2018-01-24T06:33:43Z

It's a Winbond (w25x32) 4 MB SPI flash. Signed-off-by: Álvaro Fernández Rojas Reviewed-by: Daniel Schwierzeck Reviewed-by: Jagan Teki Reviewed-by: Simon Glass