target/linux/brcm2708/patches-4.19/950-0294-gpio-ir-change-default-pull-configuration-to-up.patch

   1 From 550dce51930fca1d5dc2a00a7a6f172fbb4e5b56 Mon Sep 17 00:00:00 2001
   2 From: Matthias Reichl <hias@horus.com>
   3 Date: Wed, 9 Jan 2019 14:51:01 +0100
   4 Subject: [PATCH 294/703] gpio-ir: change default pull configuration to up
   5
   6 IR receivers like the TSOP series from Vishay and compatible ones
   7 have active-low open collector outputs with an internal pull up of
   8 about 30k (according to the TSOP datasheets).
   9
  10 Activating a pull-down resistor on the GPIO will make it work against
  11 the pull-up in the IR receiver and brings the idle input voltage down
  12 to about 1.9V (measured on a RPi3B+ with a TSOP4438). While that's
  13 usually enough to make the RPi see a high signal it's certainly not
  14 optimal and may even fail when using an IR receiver with a weaker pull-up.
  15
  16 Switching the default GPIO pull to "up" results in an input voltage
  17 level of about 3.3V and ensures that an idle state (high signal) will
  18 be detected if no IR receiver is attached.
  19
  20 Signed-off-by: Matthias Reichl <hias@horus.com>
  21 ---
  22  arch/arm/boot/dts/overlays/README              | 2 +-
  23  arch/arm/boot/dts/overlays/gpio-ir-overlay.dts | 2 +-
  24  2 files changed, 2 insertions(+), 2 deletions(-)
  25
  26 --- a/arch/arm/boot/dts/overlays/README
  27 +++ b/arch/arm/boot/dts/overlays/README
  28 @@ -611,7 +611,7 @@ Load:   dtoverlay=gpio-ir,<param>=<val>
  29  Params: gpio_pin                Input pin number. Default is 18.
  30
  31          gpio_pull               Desired pull-up/down state (off, down, up)
  32 -                                Default is "down".
  33 +                                Default is "up".
  34
  35          rc-map-name             Default rc keymap (can also be changed by
  36                                  ir-keytable), defaults to "rc-rc6-mce"
  37 --- a/arch/arm/boot/dts/overlays/gpio-ir-overlay.dts
  38 +++ b/arch/arm/boot/dts/overlays/gpio-ir-overlay.dts
  39 @@ -30,7 +30,7 @@
  40                          gpio_ir_pins: gpio_ir_pins@12 {
  41                                  brcm,pins = <18>;                       // pin 18
  42                                  brcm,function = <0>;                    // in
  43 -                                brcm,pull = <1>;                        // down
  44 +                                brcm,pull = <2>;                        // up
  45                          };
  46                  };
  47          };