target/linux/ath79/dts/qca9558_netgear_ex7300.dts

   1 // SPDX-License-Identifier: GPL-2.0-or-later OR MIT
   2
   3 #include "qca955x.dtsi"
   4
   5 #include <dt-bindings/gpio/gpio.h>
   6 #include <dt-bindings/input/input.h>
   7
   8 / {
   9         model = "Netgear EX7300";
  10         compatible = "netgear,ex7300", "qca,qca9558";
  11
  12         aliases {
  13                 led-boot = &led_power_green;
  14                 led-failsafe = &led_power_amber;
  15                 led-running = &led_power_green;
  16                 led-upgrade = &led_power_amber;
  17                 label-mac-device = &eth0;
  18         };
  19
  20         led_spi {
  21                 compatible = "spi-gpio";
  22                 #address-cells = <1>;
  23                 #size-cells = <0>;
  24
  25                 sck-gpios = <&gpio 18 GPIO_ACTIVE_HIGH>;
  26                 mosi-gpios = <&gpio 15 GPIO_ACTIVE_HIGH>;
  27                 num-chipselects = <0>;
  28
  29                 led_gpio: led_gpio@0 {
  30                         compatible = "nxp,74lvc594";
  31                         reg = <0>;
  32                         gpio-controller;
  33                         #gpio-cells = <2>;
  34                         registers-number = <1>;
  35                         spi-max-frequency = <500000>;
  36
  37                         gpio_latch_bit {
  38                                 gpio-hog;
  39                                 gpios = <4 GPIO_ACTIVE_HIGH>;
  40                                 output-high;
  41                                 line-name = "gpio-latch-bit";
  42                         };
  43                 };
  44         };
  45
  46         leds {
  47                 compatible = "gpio-leds";
  48
  49                 led_power_green: power_green {
  50                         label = "green:power";
  51                         gpios = <&gpio 19 GPIO_ACTIVE_LOW>;
  52                 };
  53
  54                 led_power_amber: power_amber {
  55                         label = "amber:power";
  56                         gpios = <&gpio 20 GPIO_ACTIVE_LOW>;
  57                 };
  58
  59                 left_blue {
  60                         label = "blue:left";
  61                         gpios = <&led_gpio 7 GPIO_ACTIVE_LOW>;
  62                 };
  63
  64                 right_blue {
  65                         label = "blue:right";
  66                         gpios = <&led_gpio 6 GPIO_ACTIVE_LOW>;
  67                 };
  68
  69                 wps_green {
  70                         label = "green:wps";
  71                         gpios = <&led_gpio 5 GPIO_ACTIVE_LOW>;
  72                 };
  73
  74                 client_red {
  75                         label = "red:client";
  76                         gpios = <&led_gpio 3 GPIO_ACTIVE_LOW>;
  77                 };
  78
  79                 client_green {
  80                         label = "green:client";
  81                         gpios = <&led_gpio 2 GPIO_ACTIVE_LOW>;
  82                 };
  83
  84                 router_red {
  85                         label = "red:router";
  86                         gpios = <&led_gpio 1 GPIO_ACTIVE_LOW>;
  87                 };
  88
  89                 router_green {
  90                         label = "green:router";
  91                         gpios = <&led_gpio 0 GPIO_ACTIVE_LOW>;
  92                 };
  93         };
  94
  95         keys {
  96                 compatible = "gpio-keys";
  97
  98                 reset {
  99                         label = "Reset button";
 100                         linux,code = <KEY_RESTART>;
 101                         gpios = <&gpio 11 GPIO_ACTIVE_LOW>;
 102                         debounce-interval = <60>;
 103                 };
 104
 105                 wps {
 106                         label = "WPS button";
 107                         linux,code = <KEY_WPS_BUTTON>;
 108                         gpios = <&gpio 22 GPIO_ACTIVE_LOW>;
 109                         debounce-interval = <60>;
 110                 };
 111
 112                 extender_apmode {
 113                         label = "EXTENDER/APMODE switch";
 114                         gpios = <&gpio 23 GPIO_ACTIVE_LOW>;
 115                         linux,code = <BTN_0>;
 116                         linux,input-type = <EV_SW>;
 117                         debounce-interval = <60>;
 118                 };
 119         };
 120 };
 121
 122 &pcie0 {
 123         status = "okay";
 124
 125         wifi@0,0 {
 126                 compatible = "qcom,ath10k";
 127                 reg = <0 0 0 0 0>;
 128
 129                 nvmem-cells = <&macaddr_caldata_c>, <&precal_caldata_5000>;
 130                 nvmem-cell-names = "mac-address", "pre-calibration";
 131         };
 132 };
 133
 134 &spi {
 135         status = "okay";
 136
 137         flash@0 {
 138                 compatible = "jedec,spi-nor";
 139                 reg = <0>;
 140                 spi-max-frequency = <25000000>;
 141
 142                 partitions {
 143                         compatible = "fixed-partitions";
 144                         #address-cells = <1>;
 145                         #size-cells = <1>;
 146
 147                         uboot: partition@0 {
 148                                 label = "u-boot";
 149                                 reg = <0x000000 0x040000>;
 150                                 read-only;
 151                         };
 152
 153                         partition@40000 {
 154                                 label = "u-boot-env";
 155                                 reg = <0x040000 0x010000>;
 156                         };
 157
 158                         caldata: partition@50000 {
 159                                 label = "caldata";
 160                                 reg = <0x050000 0x010000>;
 161                                 read-only;
 162                         };
 163
 164                         partition@60000 {
 165                                 label = "caldata-backup";
 166                                 reg = <0x060000 0x010000>;
 167                                 read-only;
 168                         };
 169
 170                         partition@70000 {
 171                                 label = "config";
 172                                 reg = <0x070000 0x010000>;
 173                         };
 174
 175                         partition@80000 {
 176                                 label = "pot";
 177                                 reg = <0x080000 0x010000>;
 178                         };
 179
 180                         partition@90000 {
 181                                 label = "firmware";
 182                                 reg = <0x090000 0xf30000>;
 183                                 compatible = "denx,uimage";
 184                         };
 185
 186                         partition@fc0000 {
 187                                 label = "language";
 188                                 reg = <0xfc0000 0x040000>;
 189                         };
 190                 };
 191         };
 192 };
 193
 194 &wmac {
 195         status = "okay";
 196
 197         nvmem-cells = <&macaddr_caldata_6>, <&cal_caldata_1000>;
 198         nvmem-cell-names = "mac-address", "calibration";
 199 };
 200
 201 &mdio0 {
 202         status = "okay";
 203
 204         phy4: ethernet-phy@4 {
 205                 reg = <4>;
 206                 phy-mode = "rgmii";
 207         };
 208 };
 209
 210 &eth0 {
 211         status = "okay";
 212
 213         nvmem-cells = <&macaddr_caldata_0>;
 214         nvmem-cell-names = "mac-address";
 215
 216         phy-handle = <&phy4>;
 217         phy-mode = "rgmii-rxid";
 218
 219         pll-data = <0x86000000 0x80000101 0x80001313>;
 220 };
 221
 222 &caldata {
 223         compatible = "nvmem-cells";
 224         #address-cells = <1>;
 225         #size-cells = <1>;
 226
 227         macaddr_caldata_0: macaddr@0 {
 228                 reg = <0x0 0x6>;
 229         };
 230
 231         macaddr_caldata_6: macaddr@6 {
 232                 reg = <0x6 0x6>;
 233         };
 234
 235         macaddr_caldata_c: macaddr@c {
 236                 reg = <0xc 0x6>;
 237         };
 238
 239         cal_caldata_1000: cal@1000 {
 240                 reg = <0x1000 0x440>;
 241         };
 242
 243         precal_caldata_5000: precal@5000 {
 244                 reg = <0x5000 0x2f20>;
 245         };
 246 };