1 // SPDX-License-Identifier: GPL-2.0-or-later OR MIT
3 #include "qca955x.dtsi"
5 #include <dt-bindings/gpio/gpio.h>
6 #include <dt-bindings/input/input.h>
9 compatible = "ocedo,ursus", "qca,qca9558";
10 model = "OCEDO Ursus";
13 compatible = "gpio-leds";
16 label = "green:wlan2g";
17 gpios = <&gpio 14 GPIO_ACTIVE_LOW>;
18 linux,default-trigger = "phy1tpt";
22 label = "green:wlan5g";
23 gpios = <&gpio 15 GPIO_ACTIVE_LOW>;
24 linux,default-trigger = "phy0tpt";
41 compatible = "jedec,spi-nor";
43 spi-max-frequency = <25000000>;
46 compatible = "fixed-partitions";
52 reg = <0x000000 0x040000>;
58 reg = <0x040000 0x010000>;
62 compatible = "denx,uimage";
64 reg = <0x050000 0x740000>;
69 reg = <0x790000 0x740000>;
75 reg = <0xed0000 0x110000>;
81 reg = <0xfe0000 0x010000>;
85 art: partition@ff0000 {
87 reg = <0xff0000 0x010000>;
97 mtd-cal-data = <&art 0x1000>;
98 mtd-mac-address = <&art 0x06>;
104 phy1: ethernet-phy@1 {
108 phy2: ethernet-phy@2 {
110 at803x-override-sgmii-link-check;
116 mtd-mac-address = <&art 0x00>;
118 phy-mode = "rgmii-rxid";
119 phy-handle = <&phy1>;
120 pll-data = <0x8e000000 0x80000101 0x80001313>;
122 gmac_config: gmac-config {
135 mtd-mac-address = <&art 0x12>;
136 phy-handle = <&phy2>;
137 pll-data = <0x3000101 0x101 0x1313>;