1 --- a/arch/arm/boot/dts/kirkwood-linksys-viper.dts
2 +++ b/arch/arm/boot/dts/kirkwood-linksys-viper.dts
7 + led-boot = &led_white_health;
8 + led-failsafe = &led_white_health;
9 + led-running = &led_white_health;
10 + led-upgrade = &led_white_health;
15 pinctrl-0 = < &pmx_led_white_health &pmx_led_white_pulse >;
16 pinctrl-names = "default";
19 + led_white_health: white-health {
20 label = "viper:white:health";
21 gpios = <&gpio0 7 GPIO_ACTIVE_HIGH>;
28 - status = "disabled";
30 + compatible = "marvell,88e6171";
41 compatible = "marvell,dsa";
50 reg = <0x200000 0x2A0000>;
56 reg = <0x4A0000 0x1760000>;
60 - label = "alt_kernel";
62 reg = <0x1C00000 0x2A0000>;
66 - label = "alt_rootfs";
68 reg = <0x1EA0000 0x1760000>;
77 - compatible = "marvell,mv88e6085";
78 - #address-cells = <1>;
83 - #address-cells = <1>;
88 - label = "ethernet1";
93 - label = "ethernet2";
98 - label = "ethernet3";
103 - label = "ethernet4";
108 - label = "internet";
114 - ethernet = <ð0port>;
125 @@ -274,10 +240,14 @@
128 /* eth1 is connected to the switch at port 6. However DSA only supports a
129 - * single CPU port. So leave this port disabled to avoid confusion.
130 + * single CPU port. Upstream uses DSA so they disable this port to avoid confusion.
133 - status = "disabled";
141 /* There is no battery on the board, so the RTC does not keep