1 --- a/arch/arm/boot/dts/kirkwood-linksys-viper.dts
2 +++ b/arch/arm/boot/dts/kirkwood-linksys-viper.dts
7 + led-boot = &led_white_health;
8 + led-failsafe = &led_white_health;
9 + led-running = &led_white_health;
10 + led-upgrade = &led_white_health;
15 pinctrl-0 = < &pmx_led_white_health &pmx_led_white_pulse >;
16 pinctrl-names = "default";
19 + led_white_health: white-health {
20 label = "viper:white:health";
21 gpios = <&gpio0 7 GPIO_ACTIVE_HIGH>;
22 + default-state = "on";
31 - status = "disabled";
33 + compatible = "marvell,88e6171";
44 compatible = "marvell,dsa";
53 reg = <0x200000 0x2A0000>;
59 reg = <0x4A0000 0x1760000>;
63 - label = "alt_kernel";
65 reg = <0x1C00000 0x2A0000>;
69 - label = "alt_rootfs";
71 reg = <0x1EA0000 0x1760000>;
80 - compatible = "marvell,mv88e6085";
81 - #address-cells = <1>;
86 - #address-cells = <1>;
91 - label = "ethernet1";
96 - label = "ethernet2";
101 - label = "ethernet3";
106 - label = "ethernet4";
111 - label = "internet";
117 - ethernet = <ð0port>;
128 @@ -274,10 +241,14 @@
131 /* eth1 is connected to the switch at port 6. However DSA only supports a
132 - * single CPU port. So leave this port disabled to avoid confusion.
133 + * single CPU port. Upstream uses DSA so they disable this port to avoid confusion.
136 - status = "disabled";
144 /* There is no battery on the board, so the RTC does not keep