1 #include <dt-bindings/interrupt-controller/irq.h>
2 #include <dt-bindings/gpio/gpio.h>
7 compatible = "lantiq,easy98000", "lantiq,falcon";
10 device_type = "memory";
11 reg = <0x0 0x4000000>;
15 compatible = "gpio-leds";
16 pinctrl-names = "default";
17 pinctrl-0 = <&bootled_pins>;
20 label = "easy98000:green:gpon";
21 gpios = <&gpio0 9 GPIO_ACTIVE_HIGH>;
22 default-state = "keep";
25 label = "easy98000:red:gpon";
26 gpios = <&gpio0 10 GPIO_ACTIVE_HIGH>;
27 default-state = "keep";
30 label = "easy98000:green:gpon_tx";
31 gpios = <&gpio0 11 GPIO_ACTIVE_HIGH>;
32 default-state = "keep";
35 label = "easy98000:green:gpon_rx";
36 gpios = <&gpio0 12 GPIO_ACTIVE_HIGH>;
37 default-state = "keep";
40 label = "easy98000:green:voice";
41 gpios = <&gpio0 13 GPIO_ACTIVE_HIGH>;
42 default-state = "keep";
45 label = "easy98000:green:status";
46 gpios = <&gpio0 14 GPIO_ACTIVE_HIGH>;
47 default-state = "keep";
54 compatible = "davicom,dm9000";
55 device_type = "network";
56 reg = <0x0000003 0x1>, <0x0000001 0x1>;
57 reg-names = "addr", "data";
58 interrupt-parent = <&gpio1>;
59 #interrupt-cells = <2>;
60 interrupts = <10 IRQ_TYPE_LEVEL_LOW>;
61 local-mac-address = [ 00 00 00 00 00 00 ];
65 compatible = "lantiq,easy98000_addon";
66 reg = <0x3c00000 0x2>;
70 compatible = "lantiq,easy98000_cpld_led";
71 reg = <0x3c0000c 0x2>, <0x3c00012 0x2>;
75 /* // enable this for second uart:
84 compatible = "atmel,at25", "atmel,at25160n";
86 spi-max-frequency = <1000000>;
99 clock-frequency = <100000>;
101 /* eeprom-emulation by OMU */
103 compatible = "at,24c02";
107 compatible = "at,24c02";