3 #include <dt-bindings/gpio/gpio.h>
4 #include <dt-bindings/input/input.h>
9 compatible = "buffalo,wzr-agl300nh", "ralink,rt2880-soc";
10 model = "Buffalo WZR-AGL300NH";
13 led-boot = &led_router;
14 led-failsafe = &led_router;
15 led-running = &led_router;
16 led-upgrade = &led_router;
20 compatible = "cfi-flash";
21 reg = <0x1f000000 0x800000>;
26 compatible = "fixed-partitions";
38 reg = <0x30000 0x10000>;
42 factory: partition@40000 {
44 reg = <0x40000 0x10000>;
49 compatible = "denx,uimage";
51 reg = <0x50000 0x3b0000>;
57 compatible = "realtek,rtl8366s";
58 gpio-sda = <&gpio0 1 GPIO_ACTIVE_HIGH>;
59 gpio-sck = <&gpio0 2 GPIO_ACTIVE_HIGH>;
63 compatible = "gpio-keys-polled";
64 poll-interval = <100>;
68 gpios = <&gpio0 0 GPIO_ACTIVE_LOW>;
69 linux,code = <KEY_WPS_BUTTON>;
73 label = "router_switch";
74 gpios = <&gpio0 7 GPIO_ACTIVE_HIGH>;
80 gpios = <&gpio0 9 GPIO_ACTIVE_LOW>;
81 linux,code = <KEY_RESTART>;
86 compatible = "gpio-leds";
89 label = "wzr-agl300nh:green:router";
90 gpios = <&gpio0 8 GPIO_ACTIVE_LOW>;
94 label = "wzr-agl300nh:red:diag";
95 gpios = <&gpio0 12 GPIO_ACTIVE_LOW>;
99 label = "wzr-agl300nh:orange:security_g";
100 gpios = <&gpio0 11 GPIO_ACTIVE_LOW>;
104 label = "wzr-agl300nh:orange:security_n";
105 gpios = <&gpio0 13 GPIO_ACTIVE_LOW>;
116 groups = "i2c", "uartlite", "mdio";
123 mtd-mac-address = <&factory 0x4>;
126 mediatek,fixed-link = <1000 1 1 1>;
132 phy0: ethernet-phy@0 {
144 ralink,mtd-eeprom = <&factory 0x0>;