3 #include <dt-bindings/gpio/gpio.h>
4 #include <dt-bindings/input/input.h>
7 compatible = "belkin,f5d8235-v2", "ralink,rt3052-soc";
8 model = "Belkin F5D8235 v2";
11 led-boot = &led_router;
12 led-failsafe = &led_router;
13 led-running = &led_router;
14 led-upgrade = &led_router;
18 compatible = "cfi-flash";
19 reg = <0x1f000000 0x800000>;
24 compatible = "fixed-partitions";
35 compatible = "denx,uimage";
37 reg = <0x50000 0x790000>;
42 reg = <0x7e0000 0x10000>;
45 factory: partition@7f0000 {
47 reg = <0x7f0000 0x10000>;
53 compatible = "realtek,rtl8366rb";
54 gpio-sda = <&gpio0 1 GPIO_ACTIVE_HIGH>;
55 gpio-sck = <&gpio0 2 GPIO_ACTIVE_HIGH>;
59 compatible = "gpio-leds";
62 label = "blue:internet";
63 gpios = <&gpio0 5 GPIO_ACTIVE_LOW>;
67 label = "amber:internet";
68 gpios = <&gpio0 6 GPIO_ACTIVE_LOW>;
73 gpios = <&gpio0 11 GPIO_ACTIVE_LOW>;
77 label = "amber:modem";
78 gpios = <&gpio0 8 GPIO_ACTIVE_LOW>;
82 label = "blue:router";
83 gpios = <&gpio0 9 GPIO_ACTIVE_LOW>;
87 label = "blue:storage";
88 gpios = <&gpio0 23 GPIO_ACTIVE_LOW>;
89 trigger-sources = <&otg_port1>;
90 linux,default-trigger = "usbport";
94 label = "amber:storage";
95 gpios = <&gpio0 22 GPIO_ACTIVE_LOW>;
99 label = "blue:security";
100 gpios = <&gpio0 13 GPIO_ACTIVE_LOW>;
104 label = "amber:security";
105 gpios = <&gpio0 12 GPIO_ACTIVE_LOW>;
112 groups = "spi", "i2c", "jtag", "mdio", "uartf";
118 mtd-mac-address = <&uboot 0x40004>;
119 pinctrl-names = "default";
120 pinctrl-0 = <&rgmii_pins>;
125 mediatek,portmap = <0x3f>;
126 ralink,fct2 = <0x0002500c>;
128 * ext phy base addr 31, rx/tx clock skew 0,
129 * turbo mii off, rgmi 3.3v off, port 5 polling off
130 * port5: enabled, gige, full-duplex, rx/tx-flow-control
131 * port6: enabled, gige, full-duplex, rx/tx-flow-control
133 ralink,fpa2 = <0x1f003fff>;
137 ralink,mtd-eeprom = <&uboot 0x40000>;