ipq40xx: only include ath10k-board-qca4019 for the generic subtarget

[openwrt/staging/chunkeey.git] / target / linux / ath79 / dts / ar7242_buffalo_wzr-bhr.dtsi

diff --git a/target/linux/ath79/dts/ar7242_buffalo_wzr-bhr.dtsi b/target/linux/ath79/dts/ar7242_buffalo_wzr-bhr.dtsi
index 3b5a4dd13d6faee868f0d8d5660463d774a0b72d..df28111598f9f07fa69a664f2c80b1ab41be2a59 100644 (file)
--- a/target/linux/ath79/dts/ar7242_buffalo_wzr-bhr.dtsi
+++ b/target/linux/ath79/dts/ar7242_buffalo_wzr-bhr.dtsi
@@ -1,16 +1,15 @@
 // SPDX-License-Identifier: GPL-2.0-or-later OR MIT
-/dts-v1/;
+
+#include "ar7242.dtsi"
 
 #include <dt-bindings/gpio/gpio.h>
 #include <dt-bindings/input/input.h>
 
-#include "ar7242.dtsi"
-
 / {
        aliases {
-               led-boot = &diag;
-               led-failsafe = &diag;
-               led-upgrade = &diag;
+               led-boot = &led_diag;
+               led-failsafe = &led_diag;
+               led-upgrade = &led_diag;
        };
 
        extosc: ref {
@@ -37,20 +36,16 @@
                };
        };
 
-       leds {
+       leds: leds {
                compatible = "gpio-leds";
 
-               sec_vpn: sec_vpn {
-                       gpios = <&gpio 13 GPIO_ACTIVE_LOW>;
-               };
-
-               diag: diag {
-                       label = "buffalo:red:diag";
+               led_diag: diag {
+                       label = "red:diag";
                        gpios = <&gpio 14 GPIO_ACTIVE_LOW>;
                };
 
                usb {
-                       label = "buffalo:green:usb";
+                       label = "green:usb";
                        gpios = <&gpio 17 GPIO_ACTIVE_LOW>;
                        trigger-sources = <&hub_port>;
                        linux,default-trigger = "usbport";
@@ -111,8 +106,6 @@
 
 &spi {
        status = "okay";
-       cs-gpios = <0>, <0>;
-       num-cs = <2>;
 
        flash0: flash@0 {
                compatible = "jedec,spi-nor";
@@ -149,10 +142,6 @@
        clocks = <&extosc>;
 };
 
-&uart {
-       status = "okay";
-};
-
 &usb_phy {
        status = "okay";
 };