#include "rt3050.dtsi"
+#include <dt-bindings/gpio/gpio.h>
+#include <dt-bindings/input/input.h>
+
/ {
- compatible = "WHR-G300N", "ralink,rt3052-soc";
+ compatible = "buffalo,whr-g300n", "ralink,rt3052-soc";
model = "Buffalo WHR-G300N";
cfi@1f000000 {
device-width = <2>;
#address-cells = <1>;
#size-cells = <1>;
+
+ partition@0 {
+ label = "u-boot";
+ reg = <0x0 0x30000>;
+ read-only;
+ };
+
+ partition@30000 {
+ label = "u-boot-env";
+ reg = <0x30000 0x10000>;
+ read-only;
+ };
+
+ factory: partition@40000 {
+ label = "factory";
+ reg = <0x40000 0x10000>;
+ read-only;
+ };
+
+ partition@50000 {
+ label = "firmware";
+ reg = <0x50000 0x3a0000>;
+ };
+
+ partition@3f0000 {
+ label = "user";
+ reg = <0x3f0000 0x10000>;
+ read-only;
+ };
};
gpio-leds {
diag {
label = "whr-g300n:red:diag";
- gpios = <&gpio0 7 1>;
+ gpios = <&gpio0 7 GPIO_ACTIVE_LOW>;
};
router {
label = "whr-g300n:green:router";
- gpios = <&gpio0 9 1>;
+ gpios = <&gpio0 9 GPIO_ACTIVE_LOW>;
};
security {
label = "whr-g300n:amber:security";
- gpios = <&gpio0 14 1>;
+ gpios = <&gpio0 14 GPIO_ACTIVE_LOW>;
};
};
reset {
label = "reset";
- gpios = <&gpio0 10 1>;
- linux,code = <0x198>;
+ gpios = <&gpio0 10 GPIO_ACTIVE_LOW>;
+ linux,code = <KEY_RESTART>;
};
aoss {
label = "aoss";
- gpios = <&gpio0 0 1>;
- linux,code = <0x211>;
+ gpios = <&gpio0 0 GPIO_ACTIVE_LOW>;
+ linux,code = <KEY_WPS_BUTTON>;
};
router-off {
label = "router-off";
- gpios = <&gpio0 11 1>;
- linux,code = <0x102>;
+ gpios = <&gpio0 11 GPIO_ACTIVE_LOW>;
+ linux,code = <BTN_2>;
};
router-on {
label = "router-on";
- gpios = <&gpio0 8 1>;
- linux,code = <0x103>;
+ gpios = <&gpio0 8 GPIO_ACTIVE_LOW>;
+ linux,code = <BTN_3>;
};
};
};
};
};
+ðernet {
+ mtd-mac-address = <&factory 0x4>;
+};
+
&esw {
mediatek,portmap = <0x2f>;
};
-/* FIXME: no partitions defined */
-/*&wmac {
+&wmac {
ralink,mtd-eeprom = <&factory 0>;
};
-*/