ralink: add pinctrl driver

[openwrt/openwrt.git] / target / linux / ramips / rt305x / config-3.10

diff --git a/target/linux/ramips/rt305x/config-3.10 b/target/linux/ramips/rt305x/config-3.10
index 90885390c9ee24429d6956195526aeddb113a981..93222447c858eeed4a6cc2e06a750b4e88fc69fe 100644 (file)
--- a/target/linux/ramips/rt305x/config-3.10
+++ b/target/linux/ramips/rt305x/config-3.10
@@ -1,7 +1,6 @@
 CONFIG_ARCH_BINFMT_ELF_RANDOMIZE_PIE=y
 CONFIG_ARCH_DISCARD_MEMBLOCK=y
 CONFIG_ARCH_HAS_ATOMIC64_DEC_IF_POSITIVE=y
-CONFIG_ARCH_HAS_RESET_CONTROLLER=y
 CONFIG_ARCH_HAVE_CUSTOM_GPIO_H=y
 CONFIG_ARCH_HIBERNATION_POSSIBLE=y
 CONFIG_ARCH_REQUIRE_GPIOLIB=y
@@ -30,6 +29,7 @@ CONFIG_CPU_R4K_FPU=y
 CONFIG_CPU_SUPPORTS_32BIT_KERNEL=y
 CONFIG_CPU_SUPPORTS_HIGHMEM=y
 CONFIG_CSRC_R4K=y
+CONFIG_DEBUG_PINCTRL=y
 CONFIG_DMA_NONCOHERENT=y
 # CONFIG_DTB_RT305X_EVAL is not set
 CONFIG_DTB_RT_NONE=y
@@ -99,12 +99,13 @@ CONFIG_MTD_M25P80=y
 CONFIG_MTD_OF_PARTS=y
 CONFIG_MTD_PHYSMAP=y
 CONFIG_MTD_PHYSMAP_OF=y
+CONFIG_MTD_SPLIT_FIRMWARE=y
 CONFIG_MTD_UIMAGE_SPLIT=y
 CONFIG_NEED_DMA_MAP_STATE=y
 CONFIG_NEED_PER_CPU_KM=y
-# CONFIG_NET_IP_TUNNEL is not set
 CONFIG_NET_RALINK=y
 CONFIG_NET_RALINK_ESW_RT3052=y
+CONFIG_NLS=m
 CONFIG_OF=y
 CONFIG_OF_ADDRESS=y
 CONFIG_OF_DEVICE=y
@@ -118,11 +119,20 @@ CONFIG_OF_NET=y
 CONFIG_PAGEFLAGS_EXTENDED=y
 CONFIG_PERF_USE_VMALLOC=y
 CONFIG_PHYLIB=y
+# CONFIG_PINCONF is not set
+CONFIG_PINCTRL=y
+CONFIG_PINCTRL_RALINK=y
+# CONFIG_PINCTRL_SINGLE is not set
+CONFIG_PINMUX=y
 # CONFIG_PREEMPT_RCU is not set
 CONFIG_RALINK=y
+CONFIG_RALINK_USBPHY=y
 CONFIG_RALINK_WDT=y
 # CONFIG_RCU_STALL_COMMON is not set
 CONFIG_RESET_CONTROLLER=y
+# CONFIG_SAMSUNG_USB2PHY is not set
+# CONFIG_SAMSUNG_USB3PHY is not set
+# CONFIG_SAMSUNG_USBPHY is not set
 # CONFIG_SCSI_DMA is not set
 CONFIG_SERIAL_8250_NR_UARTS=4
 CONFIG_SERIAL_8250_RT288X=y
@@ -135,7 +145,7 @@ CONFIG_SOC_RT305X=y
 # CONFIG_SOC_RT3883 is not set
 CONFIG_SPI=y
 CONFIG_SPI_MASTER=y
-CONFIG_SPI_RALINK=y
+CONFIG_SPI_RT2880=y
 CONFIG_SWCONFIG=y
 CONFIG_SYS_HAS_CPU_MIPS32_R1=y
 CONFIG_SYS_HAS_CPU_MIPS32_R2=y
@@ -145,7 +155,11 @@ CONFIG_SYS_SUPPORTS_ARBIT_HZ=y
 CONFIG_SYS_SUPPORTS_LITTLE_ENDIAN=y
 CONFIG_TICK_CPU_ACCOUNTING=y
 CONFIG_UIDGID_CONVERTED=y
+CONFIG_USB=m
 # CONFIG_USB_ARCH_HAS_XHCI is not set
+CONFIG_USB_COMMON=m
+# CONFIG_USB_EHCI_HCD is not set
+CONFIG_USB_PHY=y
 CONFIG_USB_SUPPORT=y
 CONFIG_USE_OF=y
 CONFIG_WATCHDOG_CORE=y