kirkwood: add support for Check Point L-50

[openwrt/openwrt.git] / target / linux / kirkwood / base-files / etc / board.d / 02_network

diff --git a/target/linux/kirkwood/base-files/etc/board.d/02_network b/target/linux/kirkwood/base-files/etc/board.d/02_network
index b83d0d25cc724521e33922eebd806480ccc4222a..658ce1334672210939092f2c5013d265b95b6a97 100755 (executable)
--- a/target/linux/kirkwood/base-files/etc/board.d/02_network
+++ b/target/linux/kirkwood/base-files/etc/board.d/02_network
@@ -11,26 +11,33 @@ board_config_update
 board=$(board_name)
 
 case "$board" in
+"checkpoint,l-50")
+       ucidef_set_interfaces_lan_wan "lan1 lan2 lan3 lan4 lan5 lan6 lan7 lan8 dmz" "eth0"
+       ;;
+"cisco,on100")
+       ucidef_set_interface_lan "eth0 eth1"
+       ;;
+"cloudengines,pogoe02"|\
+"cloudengines,pogoplugv4"|\
+"iom,iconnect-1.1"|\
+"iom,ix2-200"|\
+"raidsonic,ib-nas62x0"|\
 "seagate,dockstar"|\
 "seagate,goflexhome"|\
 "seagate,goflexnet"|\
-"raidsonic,ib-nas62x0"|\
-"iom,iconnect-1.1"|\
-"cloudengines,pogoe02")
+"zyxel,nsa310s")
        ucidef_set_interface_lan "eth0" "dhcp"
        ;;
 "linksys,audi"|\
 "linksys,viper")
-       ucidef_add_switch "switch0" \
-               "0:lan" "1:lan" "2:lan" "3:lan" "4:wan" "5@eth0" "6@eth1"
+       ucidef_set_interfaces_lan_wan "ethernet1 ethernet2 ethernet3 ethernet4" "internet"
+       ucidef_set_interface_macaddr "wan" $( mtd_get_mac_ascii u_env eth1addr )
        ;;
-"zyxel,nsa310b"|"zyxel,nsa325")
+"zyxel,nsa310b"|\
+"zyxel,nsa325")
        ucidef_set_interface_lan "eth0" "dhcp"
        ucidef_set_interface_macaddr "lan" $( mtd_get_mac_ascii uboot_env ethaddr )
        ;;
-"cisco,on100")
-       ucidef_set_interface_lan "eth0 eth1"
-       ;;
 *)
        ucidef_set_interface_lan "eth0"
        ;;