target/linux/ath79/dts/ar7161_netgear_wndr.dtsi

   1 // SPDX-License-Identifier: GPL-2.0-or-later OR MIT
   2
   3 #include <dt-bindings/gpio/gpio.h>
   4 #include <dt-bindings/input/input.h>
   5
   6 #include "ar7100.dtsi"
   7
   8 / {
   9         aliases {
  10                 led-boot = &led_power_orange;
  11                 led-failsafe = &led_power_orange;
  12                 led-running = &led_power_green;
  13                 led-upgrade = &led_power_orange;
  14                 label-mac-device = &eth0;
  15         };
  16
  17         extosc: ref {
  18                 compatible = "fixed-clock";
  19                 #clock-cells = <0>;
  20                 clock-output-names = "ref";
  21                 clock-frequency = <40000000>;
  22         };
  23
  24         reset-leds {
  25                 compatible = "reset-leds";
  26
  27                 usb_led {
  28                         label = "netgear:green:usb";
  29                         resets = <&rst 12>;
  30                         trigger-sources = <&usb_ohci_port>, <&usb_ehci_port>;
  31                         linux,default-trigger = "usbport";
  32                 };
  33         };
  34
  35         leds {
  36                 compatible = "gpio-leds";
  37
  38                 wps {
  39                         label = "netgear:orange:wps";
  40                         gpios = <&gpio 0 GPIO_ACTIVE_LOW>;
  41                 };
  42
  43                 led_power_green: power_green {
  44                         label = "netgear:green:power";
  45                         gpios = <&gpio 2 GPIO_ACTIVE_LOW>;
  46                 };
  47
  48                 led_power_orange: power_orange {
  49                         label = "netgear:orange:power";
  50                         gpios = <&gpio 1 GPIO_ACTIVE_LOW>;
  51                         default-state = "on";
  52                 };
  53
  54                 wps_green {
  55                         label = "netgear:green:wps";
  56                         gpios = <&gpio 4 GPIO_ACTIVE_LOW>;
  57                 };
  58
  59                 wan_green {
  60                         label = "netgear:green:wan";
  61                         gpios = <&gpio 6 GPIO_ACTIVE_LOW>;
  62                 };
  63         };
  64
  65         ath9k-leds {
  66                 compatible = "gpio-leds";
  67
  68                 wlan2g {
  69                         label = "netgear:green:wlan2g";
  70                         gpios = <&ath9k0 5 GPIO_ACTIVE_LOW>;
  71                         linux,default-trigger = "phy0tpt";
  72                 };
  73                 wlan5g {
  74                         label = "netgear:blue:wlan5g";
  75                         gpios = <&ath9k1 5 GPIO_ACTIVE_LOW>;
  76                         linux,default-trigger = "phy1tpt";
  77                 };
  78         };
  79
  80         keys {
  81                 compatible = "gpio-keys";
  82
  83                 wps {
  84                         label = "wps";
  85                         linux,code = <KEY_WPS_BUTTON>;
  86                         gpios = <&gpio 3 GPIO_ACTIVE_LOW>;
  87                 };
  88
  89                 reset {
  90                         label = "reset";
  91                         linux,code = <KEY_RESTART>;
  92                         gpios = <&gpio 8 GPIO_ACTIVE_LOW>;
  93                 };
  94
  95                 rfkill {
  96                         label = "rfkill";
  97                         linux,code = <KEY_RFKILL>;
  98                         gpios = <&gpio 11 GPIO_ACTIVE_LOW>;
  99                 };
 100         };
 101
 102         rtl8366s {
 103                 compatible = "realtek,rtl8366s";
 104
 105                 gpio-sda = <&gpio 5 GPIO_ACTIVE_HIGH>;
 106                 gpio-sck = <&gpio 7 GPIO_ACTIVE_HIGH>;
 107
 108                 mdio-bus {
 109                         #address-cells = <1>;
 110                         #size-cells = <0>;
 111                         status = "okay";
 112
 113                         phy-mask = <0x10>;
 114
 115                         phy4: ethernet-phy@4 {
 116                                 reg = <4>;
 117                                 phy-mode = "rgmii";
 118                         };
 119                 };
 120         };
 121 };
 122
 123 &usb_phy {
 124         status = "okay";
 125 };
 126
 127 &usb1 {
 128         #address-cells = <1>;
 129         #size-cells = <0>;
 130         status = "okay";
 131
 132         usb_ohci_port: port@1 {
 133                 reg = <1>;
 134                 #trigger-source-cells = <0>;
 135         };
 136 };
 137
 138 &usb2 {
 139         #address-cells = <1>;
 140         #size-cells = <0>;
 141         status = "okay";
 142
 143         usb_ehci_port: port@1 {
 144                 reg = <1>;
 145                 #trigger-source-cells = <0>;
 146         };
 147 };
 148
 149 &pcie0 {
 150         status = "okay";
 151
 152         ath9k0: wifi@0,11 {
 153                 compatible = "pci168c,0029";
 154                 reg = <0x8800 0 0 0 0>;
 155                 mtd-mac-address = <&art 0x0>;
 156                 qca,no-eeprom;
 157                 #gpio-cells = <2>;
 158                 gpio-controller;
 159
 160                 /* all WNDR3700 variants have four antennae dedicated
 161                  * to the 2.4GHz radio. Two antennae are available for
 162                  * each chain. The following configuration is the
 163                  * default setting which taken from the vendor's wifi
 164                  * code for that radio.
 165                  *
 166                  * All possible options [GPIO6,GPIO7,GPIO8,GPIO9]:
 167                  *      [0,1,0,1], [0,1,1,0], [1,0,0,1], [1,0,1,0]
 168                  */
 169                 antenna-demux {
 170                         gpio-hog;
 171                         line-name = "fixed antenna group 1";
 172                         gpios = <6 GPIO_ACTIVE_LOW>,
 173                                 <7 GPIO_ACTIVE_HIGH>,
 174                                 <8 GPIO_ACTIVE_LOW>,
 175                                 <9 GPIO_ACTIVE_HIGH>;
 176                         output-high;
 177                 };
 178         };
 179
 180         ath9k1: wifi@0,12 {
 181                 compatible = "pci168c,0029";
 182                 reg = <0x9000 0 0 0 0>;
 183                 mtd-mac-address = <&art 0xc>;
 184                 qca,no-eeprom;
 185                 #gpio-cells = <2>;
 186                 gpio-controller;
 187         };
 188 };
 189
 190 &uart {
 191         status = "okay";
 192 };
 193
 194 &spi {
 195         status = "okay";
 196
 197         num-cs = <1>;
 198
 199         flash@0 {
 200                 compatible = "jedec,spi-nor";
 201                 reg = <0>;
 202                 spi-max-frequency = <25000000>;
 203
 204                 partitions: partitions {
 205                         compatible = "fixed-partitions";
 206                         #address-cells = <1>;
 207                         #size-cells = <1>;
 208                 };
 209         };
 210 };
 211
 212 &eth0 {
 213         status = "okay";
 214
 215         pll-data = <0x11110000 0x00001099 0x00991099>;
 216
 217         mtd-mac-address = <&art 0x00>;
 218
 219         fixed-link {
 220                 speed = <1000>;
 221                 full-duplex;
 222         };
 223 };
 224
 225 &eth1 {
 226         status = "okay";
 227
 228         pll-data = <0x11110000 0x00001099 0x00991099>;
 229
 230         mtd-mac-address = <&art 0x06>;
 231
 232         phy-handle = <&phy4>;
 233 };