target/linux/ath79/dts/qca9558_comfast_cf-wr650ac.dtsi

   1 // SPDX-License-Identifier: GPL-2.0-or-later OR MIT
   2
   3 #include <dt-bindings/gpio/gpio.h>
   4 #include <dt-bindings/input/input.h>
   5
   6 #include "qca955x.dtsi"
   7
   8 / {
   9         keys {
  10                 compatible = "gpio-keys";
  11
  12                 reset {
  13                         label = "reset";
  14                         linux,code = <KEY_RESTART>;
  15                         gpios = <&gpio 19 GPIO_ACTIVE_LOW>;
  16                         debounce-interval = <60>;
  17                 };
  18         };
  19
  20         watchdog {
  21                 compatible = "linux,wdt-gpio";
  22                 gpios = <&gpio 17 GPIO_ACTIVE_LOW>;
  23                 hw_algo = "toggle";
  24                 hw_margin_ms = <500>;
  25                 always-running;
  26         };
  27 };
  28
  29 &pcie0 {
  30         status = "okay";
  31 };
  32
  33 &uart {
  34         status = "okay";
  35 };
  36
  37 &usb_phy0 {
  38         status = "okay";
  39 };
  40
  41 &usb0 {
  42         status = "okay";
  43 };
  44
  45 &mdio0 {
  46         status = "okay";
  47
  48         switch0@1f {
  49                 compatible = "qca,ar8327";
  50                 reg = <0x1f>;
  51                 qca,ar8327-initvals = <
  52                         0x04 0x87600000 /* PORT0 PAD MODE CTRL */
  53                         0x0c 0x00080080 /* PORT6 PAD MODE CTRL */
  54                         0x10 0x81000080 /* POWER_ON_STRIP */
  55                         0x7c 0x0000007e /* PORT0_STATUS */
  56                         0x94 0x0000007e /* PORT6 STATUS */
  57                         >;
  58         };
  59 };
  60
  61 &eth0 {
  62         status = "okay";
  63
  64         pll-data = <0xa6000000 0x00000101 0x00001616>;
  65         mtd-mac-address = <&art 0x0>;
  66         fixed-link {
  67                 speed = <1000>;
  68                 full-duplex;
  69         };
  70 };
  71
  72 &eth1 {
  73         status = "okay";
  74
  75         pll-data = <0x03000101 0x00000101 0x00001616>;
  76         mtd-mac-address = <&art 0x6>;
  77         fixed-link {
  78                 speed = <1000>;
  79                 full-duplex;
  80         };
  81 };
  82
  83 &wmac {
  84         status = "okay";
  85
  86         mtd-cal-data = <&art 0x1000>;
  87         mtd-mac-address = <&art 0x18>;
  88 };
  89
  90 // This node is required for the Ethernet ports to work correctly.
  91 &gpio {
  92         status = "okay";
  93 };