target/linux/kirkwood/patches-4.9/105-ea4500.patch

   1 --- a/arch/arm/boot/dts/kirkwood-linksys-viper.dts
   2 +++ b/arch/arm/boot/dts/kirkwood-linksys-viper.dts
   3 @@ -69,6 +69,17 @@
   4                 };
   5         };
   6
   7 +       mvsw61xx {
   8 +               compatible = "marvell,88e6171";
   9 +               status = "okay";
  10 +               reg = <0x10>;
  11 +
  12 +               mii-bus = <&mdio>;
  13 +               cpu-port-0 = <5>;
  14 +               cpu-port-1 = <6>;
  15 +               is-indirect;
  16 +       };
  17 +
  18         dsa {
  19                 compatible = "marvell,dsa";
  20                 #address-cells = <2>;
  21 @@ -161,22 +172,22 @@
  22                 };
  23
  24                 partition@200000 {
  25 -                       label = "kernel";
  26 +                       label = "kernel1";
  27                         reg = <0x200000 0x2A0000>;
  28                 };
  29
  30                 partition@4A0000 {
  31 -                       label = "rootfs";
  32 +                       label = "rootfs1";
  33                         reg = <0x4A0000 0x1760000>;
  34                 };
  35
  36                 partition@1C00000 {
  37 -                       label = "alt_kernel";
  38 +                       label = "kernel2";
  39                         reg = <0x1C00000 0x2A0000>;
  40                 };
  41
  42                 partition@1EA0000 {
  43 -                       label = "alt_rootfs";
  44 +                       label = "rootfs2";
  45                         reg = <0x1EA0000 0x1760000>;
  46                 };
  47
  48 @@ -225,10 +236,14 @@
  49  };
  50
  51  /* eth1 is connected to the switch at port 6. However DSA only supports a
  52 - * single CPU port. So leave this port disabled to avoid confusion.
  53 + * single CPU port. Upstream uses DSA so they disable this port to avoid confusion.
  54   */
  55  &eth1 {
  56 -       status = "disabled";
  57 +       status = "okay";
  58 +       ethernet1-port@0 {
  59 +               speed = <1000>;
  60 +               duplex = <1>;
  61 +       };
  62  };
  63
  64  /* There is no battery on the board, so the RTC does not keep