target/linux/ath79/dts/qca9557_dlink_dap-2660-a1.dts

   1 // SPDX-License-Identifier: GPL-2.0-or-later OR MIT
   2
   3 #include "qca955x.dtsi"
   4 #include "qca95xx_dlink_dap-2xxx.dtsi"
   5
   6 / {
   7         compatible = "dlink,dap-2660-a1", "qca,qca9557";
   8         model = "D-Link DAP-2660 A1";
   9
  10         aliases {
  11                 led-boot = &led_power_green;
  12                 led-failsafe = &led_power_red;
  13                 led-running = &led_power_green;
  14                 led-upgrade = &led_power_red;
  15         };
  16
  17         keys {
  18                 compatible = "gpio-keys";
  19
  20                 reset {
  21                         label = "reset";
  22                         linux,code = <KEY_RESTART>;
  23                         gpios = <&gpio 17 GPIO_ACTIVE_LOW>;
  24                 };
  25         };
  26
  27         leds {
  28                 compatible = "gpio-leds";
  29
  30                 led_power_red: power_red {
  31                         label = "red:power";
  32                         gpios = <&gpio 14 GPIO_ACTIVE_LOW>;
  33                 };
  34
  35                 led_power_green: power_green {
  36                         label = "green:power";
  37                         gpios = <&gpio 23 GPIO_ACTIVE_LOW>;
  38                         default-state = "on";
  39                 };
  40         };
  41 };
  42
  43 &partitions {
  44         partition@70000 {
  45                 label = "firmware";
  46                 reg = <0x70000 0xee0000>;
  47                 compatible = "wrg";
  48         };
  49
  50         partition@f50000 {
  51                 label = "dlink";
  52                 reg = <0xf50000 0xa0000>;
  53                 read-only;
  54         };
  55
  56         art: partition@ff0000 {
  57                 label = "art";
  58                 reg = <0xff0000 0x10000>;
  59                 read-only;
  60         };
  61 };
  62
  63 &mdio0 {
  64         status = "okay";
  65
  66         phy0: ethernet-phy@4 {
  67                 reg = <0x4>;
  68         };
  69 };
  70
  71 &eth0 {
  72         status = "okay";
  73
  74         pll-data = <0x82000000 0x80000101 0x80001313>;
  75
  76         phy-handle = <&phy0>;
  77         phy-mode = "rgmii-id";
  78
  79         gmac-config {
  80                 device = <&gmac>;
  81                 rgmii-enabled = <1>;
  82                 rxd-delay = <3>;
  83                 rxdv-delay = <3>;
  84         };
  85 };
  86
  87 &pcie0 {
  88         status = "okay";
  89 };