target/linux/ath79/dts/qca9558_comfast_cf-wr650ac.dtsi

   1 // SPDX-License-Identifier: GPL-2.0-or-later OR MIT
   2
   3 #include <dt-bindings/gpio/gpio.h>
   4 #include <dt-bindings/input/input.h>
   5
   6 #include "qca9557.dtsi"
   7
   8 / {
   9         chosen {
  10                 bootargs = "console=ttyS0,115200n8";
  11         };
  12
  13         keys {
  14                 compatible = "gpio-keys";
  15
  16                 reset {
  17                         label = "reset";
  18                         linux,code = <KEY_RESTART>;
  19                         gpios = <&gpio 19 GPIO_ACTIVE_LOW>;
  20                         debounce-interval = <60>;
  21                 };
  22         };
  23
  24         watchdog {
  25                 compatible = "linux,wdt-gpio";
  26                 gpios = <&gpio 17 GPIO_ACTIVE_LOW>;
  27                 hw_algo = "toggle";
  28                 hw_margin_ms = <500>;
  29                 always-running;
  30         };
  31 };
  32
  33 &pcie0 {
  34         status = "okay";
  35 };
  36
  37 &uart {
  38         status = "okay";
  39 };
  40
  41 &usb_phy0 {
  42         status = "okay";
  43 };
  44
  45 &usb0 {
  46         status = "okay";
  47 };
  48
  49 &mdio0 {
  50         status = "okay";
  51
  52         switch0@1f {
  53                 compatible = "qca,ar8327";
  54                 reg = <0x1f>;
  55                 qca,ar8327-initvals = <
  56                         0x04 0x87600000 /* PORT0 PAD MODE CTRL */
  57                         0x0c 0x00080080 /* PORT6 PAD MODE CTRL */
  58                         0x10 0x81000080 /* POWER_ON_STRIP */
  59                         0x7c 0x0000007e /* PORT0_STATUS */
  60                         0x94 0x0000007e /* PORT6 STATUS */
  61                         >;
  62         };
  63 };
  64
  65 &eth0 {
  66         status = "okay";
  67
  68         pll-data = <0xa6000000 0x00000101 0x00001616>;
  69         mtd-mac-address = <&art 0x0>;
  70         fixed-link {
  71                 speed = <1000>;
  72                 full-duplex;
  73         };
  74 };
  75
  76 &eth1 {
  77         status = "okay";
  78
  79         pll-data = <0x03000101 0x00000101 0x00001616>;
  80         mtd-mac-address = <&art 0x6>;
  81         fixed-link {
  82                 speed = <1000>;
  83                 full-duplex;
  84         };
  85 };
  86
  87 &wmac {
  88         status = "okay";
  89
  90         mtd-cal-data = <&art 0x1000>;
  91         mtd-mac-address = <&art 0x18>;
  92 };
  93
  94 // This node is required for the Ethernet ports to work correctly.
  95 &gpio {
  96         status = "okay";
  97 };