target/linux/bcm63xx/dts/bcm6328-brcm-bcm96328avng.dts

   1 /dts-v1/;
   2
   3 #include "bcm6328.dtsi"
   4
   5 #include <dt-bindings/input/input.h>
   6
   7 / {
   8         model = "Broadcom BCM96328avng reference board";
   9         compatible = "brcm,bcm96328avng", "brcm,bcm6328";
  10
  11         aliases {
  12                 led-boot = &led_power;
  13                 led-failsafe = &led_power;
  14                 led-running = &led_power;
  15                 led-upgrade = &led_power;
  16         };
  17
  18         chosen {
  19                 bootargs = "rootfstype=squashfs,jffs2 noinitrd console=ttyS0,115200";
  20                 stdout-path = "serial0:115200n8";
  21         };
  22
  23         leds {
  24                 compatible = "gpio-leds";
  25
  26                 inet_fail {
  27                         label = "96328avng::internet-fail";
  28                         gpios = <&pinctrl 2 1>;
  29                 };
  30                 dsl {
  31                         label = "96328avng::dsl";
  32                         gpios = <&pinctrl 3 1>;
  33                 };
  34                 led_power: power {
  35                         label = "96328avng::power";
  36                         gpios = <&pinctrl 4 1>;
  37                         default-state = "on";
  38                 };
  39                 power_fail {
  40                         label = "96328avng::power-fail";
  41                         gpios = <&pinctrl 8 1>;
  42                 };
  43                 wps {
  44                         label = "96328avng::wps";
  45                         gpios = <&pinctrl 9 1>;
  46                 };
  47                 inet {
  48                         label = "96328avng::internet";
  49                         gpios = <&pinctrl 11 1>;
  50                 };
  51         };
  52 };
  53
  54 &hsspi {
  55         status = "ok";
  56
  57         flash@0 {
  58                 compatible = "jedec,spi-nor";
  59                 spi-max-frequency = <16666667>;
  60                 spi-tx-bus-width = <2>;
  61                 spi-rx-bus-width = <2>;
  62                 reg = <0>;
  63
  64                 #address-cells = <1>;
  65                 #size-cells = <1>;
  66
  67                 partitions {
  68                         compatible = "brcm,bcm963xx-cfe-nor-partitions";
  69                 };
  70         };
  71 };
  72
  73 &pinctrl {
  74         pinctrl-names = "default";
  75         pinctrl-0 = <&pinctrl_usb_port1_device>;
  76 };
  77
  78 &uart0 {
  79         status = "ok";
  80 };