target/linux/generic/pending-5.4/735-net-phy-at803x-fix-at8033-sgmii-mode.patch

   1 From: Roman Yeryomin <roman@advem.lv>
   2 Subject: kernel: add at803x fix for sgmii mode
   3
   4 Some (possibly broken) bootloaders incorreclty initialize at8033
   5 phy. This patch enables sgmii autonegotiation mode.
   6
   7 [john@phrozen.org: felix added this to his upstream queue]
   8
   9 Signed-off-by: Roman Yeryomin <roman@advem.lv>
  10 ---
  11  drivers/net/phy/at803x.c | 25 +++++++++++++++++++++++++
  12  1 file changed, 25 insertions(+)
  13
  14 --- a/drivers/net/phy/at803x.c
  15 +++ b/drivers/net/phy/at803x.c
  16 @@ -46,6 +46,7 @@
  17  #define AT803X_LOC_MAC_ADDR_32_47_OFFSET       0x804A
  18  #define AT803X_REG_CHIP_CONFIG                 0x1f
  19  #define AT803X_BT_BX_REG_SEL                   0x8000
  20 +#define AT803X_SGMII_ANEG_EN                   0x1000
  21
  22  #define AT803X_DEBUG_ADDR                      0x1D
  23  #define AT803X_DEBUG_DATA                      0x1E
  24 @@ -259,6 +260,27 @@ static int at803x_probe(struct phy_devic
  25  static int at803x_config_init(struct phy_device *phydev)
  26  {
  27         int ret;
  28 +       u32 v;
  29 +
  30 +       if (phydev->drv->phy_id == ATH8031_PHY_ID &&
  31 +               phydev->interface == PHY_INTERFACE_MODE_SGMII)
  32 +       {
  33 +               v = phy_read(phydev, AT803X_REG_CHIP_CONFIG);
  34 +               /* select SGMII/fiber page */
  35 +               ret = phy_write(phydev, AT803X_REG_CHIP_CONFIG,
  36 +                                               v & ~AT803X_BT_BX_REG_SEL);
  37 +               if (ret)
  38 +                       return ret;
  39 +               /* enable SGMII autonegotiation */
  40 +               ret = phy_write(phydev, MII_BMCR, AT803X_SGMII_ANEG_EN);
  41 +               if (ret)
  42 +                       return ret;
  43 +               /* select copper page */
  44 +               ret = phy_write(phydev, AT803X_REG_CHIP_CONFIG,
  45 +                                               v | AT803X_BT_BX_REG_SEL);
  46 +               if (ret)
  47 +                       return ret;
  48 +       }
  49
  50         /* The RX and TX delay default is:
  51          *   after HW reset: RX delay enabled and TX delay disabled