target/linux/ramips/dts/rt2880_ralink_v11st-fe.dts

   1 #include "rt2880.dtsi"
   2
   3 #include <dt-bindings/gpio/gpio.h>
   4 #include <dt-bindings/input/input.h>
   5
   6 / {
   7         compatible = "ralink,v11st-fe", "ralink,rt2880-soc";
   8         model = "Ralink V11ST-FE";
   9
  10         aliases {
  11                 led-boot = &led_status;
  12                 led-failsafe = &led_status;
  13                 led-running = &led_status;
  14                 led-upgrade = &led_status;
  15         };
  16
  17         flash@1c000000 {
  18                 compatible = "cfi-flash";
  19                 reg = <0x1c000000 0x800000>;
  20                 bank-width = <2>;
  21
  22                 partitions {
  23                         compatible = "fixed-partitions";
  24                         #address-cells = <1>;
  25                         #size-cells = <1>;
  26
  27                         partition@0 {
  28                                 reg = <0x0 0x0030000>;
  29                                 label = "u-boot";
  30                                 read-only;
  31                         };
  32
  33                         partition@30000 {
  34                                 reg = <0x00030000 0x00010000>;
  35                                 label = "u-boot-env";
  36                                 read-only;
  37                         };
  38
  39                         factory: partition@40000 {
  40                                 reg = <0x00040000 0x00010000>;
  41                                 label = "factory";
  42                                 read-only;
  43                         };
  44
  45                         partition@50000 {
  46                                 compatible = "denx,uimage";
  47                                 reg = <0x00050000 0x003b0000>;
  48                                 label = "firmware";
  49                         };
  50                 };
  51         };
  52
  53         keys {
  54                 compatible = "gpio-keys-polled";
  55                 poll-interval = <100>;
  56
  57                 wps {
  58                         label = "wps";
  59                         gpios = <&gpio0 0 GPIO_ACTIVE_HIGH>;
  60                         linux,code = <KEY_WPS_BUTTON>;
  61                 };
  62         };
  63
  64         leds {
  65                 compatible = "gpio-leds";
  66
  67                 led_status: status {
  68                         label = "green:status";
  69                         gpios = <&gpio0 12 GPIO_ACTIVE_LOW>;
  70                 };
  71         };
  72 };
  73
  74 &ethernet {
  75         status = "okay";
  76 };
  77
  78 &pci {
  79         status = "okay";
  80 };
  81
  82 &wmac {
  83         ralink,mtd-eeprom = <&factory 0x0>;
  84 };