The VoCore2 features 128MB of RAM, therefore set
memory in DTS to 128*1024*1024 = 0x8000000
The board's LED is connected to GND, set it to
ACTIVE_HIGH here.
Make serial console working again on kernel 4.9 by
change of pinmux configuration.
Signed-off-by: Paul Wassi <p.wassi@gmx.at>
memory@0 {
device_type = "memory";
memory@0 {
device_type = "memory";
status {
label = "vocore2:fuchsia:status";
status {
label = "vocore2:fuchsia:status";
- gpios = <&gpio1 12 GPIO_ACTIVE_LOW>;
+ gpios = <&gpio1 12 GPIO_ACTIVE_HIGH>;
&pinctrl {
state_default: pinctrl0 {
gpio {
&pinctrl {
state_default: pinctrl0 {
gpio {
- ralink,group = "refclk", "gpio";
+ ralink,group = "wled_an", "perst", "wdt";
ralink,function = "gpio";
};
ralink,function = "gpio";
};
-
- agpio {
- ralink,group = "agpio";
- ralink,function = "uart2";
- };
- };
-
- uart1_pins: uart1 {
- uart1 {
- ralink,group = "uart1";
- ralink,function = "uart1";
- };
- };
-
- uart2_pins: uart2 {
- uart2 {
- ralink,group = "spis";
- ralink,function = "pwm";
- };