target/linux/bcm63xx/dts/bcm6328-brcm-bcm96328avng.dts

   1 #include "bcm6328.dtsi"
   2
   3 #include <dt-bindings/input/input.h>
   4
   5 / {
   6         model = "Broadcom BCM96328avng reference board";
   7         compatible = "brcm,bcm96328avng", "brcm,bcm6328";
   8
   9         aliases {
  10                 led-boot = &led_power;
  11                 led-failsafe = &led_power;
  12                 led-running = &led_power;
  13                 led-upgrade = &led_power;
  14         };
  15
  16         chosen {
  17                 bootargs = "rootfstype=squashfs,jffs2 noinitrd console=ttyS0,115200";
  18                 stdout-path = "serial0:115200n8";
  19         };
  20
  21         leds {
  22                 compatible = "gpio-leds";
  23
  24                 inet_fail {
  25                         label = "internet-fail";
  26                         gpios = <&pinctrl 2 1>;
  27                 };
  28                 dsl {
  29                         label = "dsl";
  30                         gpios = <&pinctrl 3 1>;
  31                 };
  32                 led_power: power {
  33                         label = "power";
  34                         gpios = <&pinctrl 4 1>;
  35                         default-state = "on";
  36                 };
  37                 power_fail {
  38                         label = "power-fail";
  39                         gpios = <&pinctrl 8 1>;
  40                 };
  41                 wps {
  42                         label = "wps";
  43                         gpios = <&pinctrl 9 1>;
  44                 };
  45                 inet {
  46                         label = "internet";
  47                         gpios = <&pinctrl 11 1>;
  48                 };
  49         };
  50 };
  51
  52 &hsspi {
  53         status = "okay";
  54
  55         flash@0 {
  56                 compatible = "jedec,spi-nor";
  57                 spi-max-frequency = <16666667>;
  58                 spi-tx-bus-width = <2>;
  59                 spi-rx-bus-width = <2>;
  60                 reg = <0>;
  61
  62                 #address-cells = <1>;
  63                 #size-cells = <1>;
  64
  65                 partitions {
  66                         compatible = "brcm,bcm963xx-cfe-nor-partitions";
  67                 };
  68         };
  69 };
  70
  71 &pinctrl {
  72         pinctrl-names = "default";
  73         pinctrl-0 = <&pinctrl_usb_port1_device>;
  74 };
  75
  76 &uart0 {
  77         status = "okay";
  78 };