target/linux/brcm63xx/dts/bcm96328avng.dts

   1 /dts-v1/;
   2
   3 #include "bcm6328.dtsi"
   4
   5 #include <dt-bindings/input/input.h>
   6
   7 / {
   8         model = "Broadcom BCM96328avng reference board";
   9         compatible = "brcm,bcm96328avng", "brcm,bcm6328";
  10
  11         chosen {
  12                 bootargs = "root=/dev/mtdblock2 rootfstype=squashfs,jffs2 noinitrd console=ttyS0,115200";
  13                 stdout-path = "serial0:115200n8";
  14         };
  15
  16         gpio-leds {
  17                 compatible = "gpio-leds";
  18
  19                 inet_fail {
  20                         label = "96328avng::internet-fail";
  21                         gpios = <&pinctrl 2 1>;
  22                 };
  23                 dsl {
  24                         label = "96328avng::dsl";
  25                         gpios = <&pinctrl 3 1>;
  26                 };
  27                 power {
  28                         label = "96328avng::power";
  29                         gpios = <&pinctrl 4 1>;
  30                         default-state = "on";
  31                 };
  32                 power_fail {
  33                         label = "96328avng::power-fail";
  34                         gpios = <&pinctrl 8 1>;
  35                 };
  36                 wps {
  37                         label = "96328avng::wps";
  38                         gpios = <&pinctrl 9 1>;
  39                 };
  40                 inet {
  41                         label = "96328avng::internet";
  42                         gpios = <&pinctrl 11 1>;
  43                 };
  44         };
  45 };
  46
  47 &hsspi {
  48         status = "ok";
  49
  50         flash@0 {
  51                 compatible = "jedec,spi-nor";
  52                 spi-max-frequency = <16666667>;
  53                 spi-tx-bus-width = <2>;
  54                 spi-rx-bus-width = <2>;
  55                 reg = <0>;
  56
  57                 #address-cells = <1>;
  58                 #size-cells = <1>;
  59
  60                 linux,part-probe = "bcm63xxpart";
  61         };
  62 };
  63
  64 &pinctrl {
  65         pinctrl-names = "default";
  66         pinctrl-0 = <&pinctrl_usb_port1_device>;
  67 };
  68
  69 &uart0 {
  70         status = "ok";
  71 };