target/linux/lantiq/dts/ARV7510PW22.dts

   1 /dts-v1/;
   2
   3 /include/ "danube.dtsi"
   4
   5 / {
   6         model = "ARV7510PW22 - Astoria Networks";
   7
   8         chosen {
   9                 bootargs = "console=ttyLTQ0,115200 init=/etc/preinit";
  10
  11                 leds {
  12                         boot = &power;
  13                         failsafe = &power;
  14                         running = &power;
  15
  16                         internet = &internet;
  17                         wifi = &wlan;
  18                 };
  19         };
  20
  21         memory@0 {
  22                 reg = <0x0 0x4000000>;
  23         };
  24
  25         sram@1F000000 {
  26                 vmmc@107000 {
  27                         status = "okay";
  28                         gpios = <&gpio 9 0>;
  29                 };
  30         };
  31
  32         fpi@10000000 {
  33                 localbus@0 {
  34                         nor-boot@0 {
  35                                 compatible = "lantiq,nor";
  36                                 bank-width = <2>;
  37                                 reg = <0 0x0 0x1000000>;
  38                                 #address-cells = <1>;
  39                                 #size-cells = <1>;
  40
  41                                 partition@0 {
  42                                         label = "uboot";
  43                                         reg = <0x00000 0x40000>;
  44                                         read-only;
  45                                 };
  46
  47                                 partition@40000 {
  48                                         label = "uboot_env";
  49                                         reg = <0x40000 0x20000>;
  50                                         read-only;
  51                                 };
  52
  53                                 partition@60000 {
  54                                         label = "firmware";
  55                                         reg = <0x60000 0xf80000>;
  56                                 };
  57
  58                                 partition@fe0000 {
  59                                         label = "board_config";
  60                                         reg = <0xfe0000 0x20000>;
  61                                         read-only;
  62                                 };
  63                         };
  64
  65                         mac_addr {
  66                                 compatible = "lantiq,eth-mac";
  67                                 reg = <0 0xfe0016 0x6>;
  68                                 mac-increment = <2>;
  69                         };
  70                 };
  71
  72                 gpio: pinmux@E100B10 {
  73                         pinctrl-names = "default";
  74                         pinctrl-0 = <&state_default>;
  75
  76                         state_default: pinmux {
  77                                 exin {
  78                                         lantiq,groups = "exin1";
  79                                         lantiq,function = "exin";
  80                                         lantiq,pull = <2>;
  81                                         lantiq,output = <0>;
  82                                 };
  83                                 pci_in {
  84                                         lantiq,groups = "req1", "req2";
  85                                         lantiq,function = "pci";
  86                                         lantiq,open-drain = <1>;
  87                                         lantiq,pull = <2>;
  88                                         lantiq,output = <0>;
  89                                 };
  90                                 pci_out {
  91                                         lantiq,groups = "gnt1";
  92                                         lantiq,function = "pci";
  93                                         lantiq,output = <1>;
  94                                 };
  95                                 pci_rst {
  96                                         lantiq,pins = "io21";
  97                                         lantiq,pull = <2>;
  98                                         lantiq,output = <1>;
  99                                 };
 100                                 pins_out {
 101                                         lantiq,pins = "io2", "io4", "io8", "io9", "io10", "io15", "io20";
 102                                         lantiq,output = <1>;
 103                                 };
 104                                 pins_in {
 105                                         lantiq,pins = "io11", "io12", "io28";
 106                                         lantiq,open-drain = <1>;
 107                                         lantiq,pull = <2>;
 108                                         lantiq,output = <0>;
 109                                 };
 110                         };
 111                 };
 112
 113                 ifxhcd@E101000 {
 114                         status = "okay";
 115                         gpios = <&gpio 8 0>;
 116                 };
 117
 118                 etop@E180000 {
 119                         phy-mode = "mii";
 120                         /* Switch reset 19 */
 121                 };
 122
 123                 pci@E105400 {
 124                         status = "okay";
 125                         lantiq,external-clock;
 126                         interrupt-map = <
 127                                 0x7000 0 0 1 &icu0 30
 128                                 0x7800 0 0 1 &icu0 135
 129                                 0x7800 0 0 2 &icu0 135
 130                                 0x7800 0 0 3 &icu0 135
 131                         >;
 132                         gpio-reset = <&gpio 21 0>;
 133                         req-mask = <0x3>;
 134                 };
 135         };
 136
 137         ralink_eep {
 138                 compatible = "ralink,eeprom";
 139                 ralink,eeprom = "RT2860.eeprom";
 140         };
 141
 142         gpio-keys-polled {
 143                 compatible = "gpio-keys-polled";
 144                 #address-cells = <1>;
 145                 #size-cells = <0>;
 146                 poll-interval = <100>;
 147
 148                 rfkill {
 149                         label = "rfkill";
 150                         gpios = <&gpio 11 1>;
 151                         linux,code = <0xf7>;
 152                 };
 153                 restart {
 154                         label = "restart";
 155                         gpios = <&gpio 12 1>;
 156                         linux,code = <0x100>;
 157                 };
 158                 reset {
 159                         label = "reset";
 160                         gpios = <&gpio 28 1>;
 161                         linux,code = <0x198>;
 162                 };
 163         };
 164
 165         gpio-leds {
 166                 compatible = "gpio-leds";
 167                 power: power {
 168                         label = "power";
 169                         gpios = <&gpio 2 1>;
 170                         default-state = "keep";
 171                 };
 172                 internet: internet {
 173                         label = "internet";
 174                         gpios = <&gpio 4 1>;
 175                 };
 176                 wlan: wlan {
 177                         label = "wlan";
 178                         gpios = <&gpio 10 1>;
 179                 };
 180                 3g {
 181                         label = "3g";
 182                         gpios = <&gpio 15 1>;
 183                 };
 184                 message {
 185                         label = "message";
 186                         gpios = <&gpio 20 1>;
 187                 };
 188         };
 189 };