lantiq: move partitions into partion table node
[openwrt/staging/mkresin.git] / target / linux / lantiq / dts / VGV7510KW22.dtsi
1 /include/ "vr9.dtsi"
2
3 / {
4 model = "VGV7510KW22 - o2 Box 6431";
5
6 chosen {
7 bootargs = "console=ttyLTQ0,115200 init=/etc/preinit";
8
9 leds {
10 boot = &power_green;
11 failsafe = &power_red;
12 running = &power_green;
13
14 dsl = &dsl;
15 internet = &internet_green;
16 wifi = &wifi;
17 };
18 };
19
20 memory@0 {
21 reg = <0x0 0x4000000>;
22 };
23
24 fpi@10000000 {
25 localbus@0 {
26 nor-boot@0 {
27 compatible = "lantiq,nor";
28 bank-width = <2>;
29 reg = <0 0x0 0x1000000>;
30 #address-cells = <1>;
31 #size-cells = <1>;
32
33 partitions {
34 compatible = "fixed-partitions";
35 #address-cells = <1>;
36 #size-cells = <1>;
37
38 boardconfig: partition@fe0000 {
39 label = "board_config";
40 reg = <0xfe0000 0x20000>;
41 read-only;
42 };
43 };
44 };
45 };
46
47 gpio: pinmux@E100B10 {
48 pinctrl-names = "default";
49 pinctrl-0 = <&state_default>;
50
51 state_default: pinmux {
52 ip101a-rst {
53 lantiq,pins = "io46";
54 lantiq,output = <0>;
55 lantiq,pull = <1>;
56 };
57 gphy-leds {
58 lantiq,groups = "gphy0 led1",
59 "gphy1 led0", "gphy1 led1";
60 lantiq,function = "gphy";
61 lantiq,open-drain = <0>;
62 lantiq,pull = <0>;
63 lantiq,output = <1>;
64 };
65 stp {
66 lantiq,groups = "stp";
67 lantiq,function = "stp";
68 lantiq,pull = <2>;
69 lantiq,open-drain = <0>;
70 lantiq,output = <1>;
71 };
72 mdio {
73 lantiq,groups = "mdio";
74 lantiq,function = "mdio";
75 };
76 pci-rst {
77 lantiq,pins = "io21";
78 lantiq,open-drain = <0>;
79 lantiq,pull = <0>;
80 lantiq,output = <1>;
81 };
82 spi {
83 lantiq,groups = "spi_di", "spi_do", "spi_clk";
84 lantiq,function = "spi";
85 };
86 };
87 };
88
89 stp: stp@E100BB0 {
90 compatible = "lantiq,gpio-stp-xway";
91 reg = <0xE100BB0 0x40>;
92 #gpio-cells = <2>;
93 gpio-controller;
94
95 lantiq,shadow = <0xff>;
96 lantiq,groups = <0x1>;
97 lantiq,dsl = <0x0>;
98 lantiq,phy1 = <0x7>;
99 lantiq,phy2 = <0x7>; /* enable gphy0 led2 = LAN2 LED */
100 };
101
102 ifxhcd@E101000 {
103 status = "okay";
104 gpios = <&gpio 47 0>;
105 };
106
107 pci@E105400 {
108 status = "okay";
109 lantiq,bus-clock = <33333333>;
110 interrupt-map-mask = <0xf800 0x0 0x0 0x7>;
111 interrupt-map = <
112 0x7000 0 0 1 &icu0 30 1 // slot 14, irq 30
113 >;
114 gpio-reset = <&gpio 21 0>;
115 req-mask = <0x1>; /* GNT1 */
116 };
117
118 pcie@d900000 {
119 status = "disabled";
120 };
121 };
122
123 gphy-xrx200 {
124 compatible = "lantiq,phy-xrx200";
125 firmware1 = "lantiq/vr9_phy22f_a1x.bin"; /*VR9 1.1*/
126 firmware2 = "lantiq/vr9_phy22f_a2x.bin"; /*VR9 1.2*/
127 phys = [ 00 01 ];
128 };
129
130 ralink_eep {
131 compatible = "ralink,eeprom";
132 ralink,eeprom = "RT3062.eeprom";
133 };
134
135 gpio-keys-polled {
136 compatible = "gpio-keys-polled";
137 #address-cells = <1>;
138 #size-cells = <0>;
139 poll-interval = <100>;
140
141 reset {
142 label = "reset";
143 gpios = <&gpio 6 1>;
144 linux,code = <0x198>;
145 };
146
147 wps {
148 label = "wps";
149 gpios = <&gpio 9 1>;
150 linux,code = <0x211>;
151 };
152 };
153
154 gpio-leds {
155 compatible = "gpio-leds";
156
157 dsl: dsl {
158 label = "vgv7510kw22:green:dsl";
159 gpios = <&gpio 2 1>;
160 };
161
162 internet_red {
163 label = "vgv7510kw22:red:internet";
164 gpios = <&gpio 10 1>;
165 };
166
167 info_red {
168 label = "vgv7510kw22:red:info";
169 gpios = <&gpio 12 1>;
170 };
171
172 power_green: power {
173 label = "vgv7510kw22:green:power";
174 gpios = <&gpio 14 1>;
175 default-state = "keep";
176 };
177
178 info_green {
179 label = "vgv7510kw22:green:info";
180 gpios = <&gpio 15 1>;
181 };
182
183 internet_green: internet_green {
184 label = "vgv7510kw22:green:internet";
185 gpios = <&gpio 19 1>;
186 };
187
188 wifi: wifi {
189 label = "vgv7510kw22:green:wlan";
190 gpios = <&gpio 20 1>;
191 };
192
193 power_red: power2 {
194 label = "vgv7510kw22:red:power";
195 gpios = <&gpio 28 1>;
196 };
197
198 phone {
199 label = "vgv7510kw22:green:telefon";
200 gpios = <&gpio 29 1>;
201 };
202 };
203 };
204
205 &eth0 {
206 lan: interface@0 {
207 compatible = "lantiq,xrx200-pdi";
208 #address-cells = <1>;
209 #size-cells = <0>;
210 reg = <0>;
211 mtd-mac-address = <&boardconfig 0x16>;
212 lantiq,switch;
213
214 ethernet@2 {
215 compatible = "lantiq,xrx200-pdi-port";
216 reg = <2>;
217 phy-mode = "mii";
218 phy-handle = <&phy11>;
219 };
220 ethernet@3 {
221 compatible = "lantiq,xrx200-pdi-port";
222 reg = <3>;
223 phy-mode = "mii";
224 phy-handle = <&phy12>;
225 };
226 ethernet@4 {
227 compatible = "lantiq,xrx200-pdi-port";
228 reg = <4>;
229 phy-mode = "mii";
230 phy-handle = <&phy13>;
231 };
232 ethernet@5 {
233 compatible = "lantiq,xrx200-pdi-port";
234 reg = <5>;
235 phy-mode = "mii";
236 phy-handle = <&phy14>;
237 };
238 };
239
240 mdio@0 {
241 #address-cells = <1>;
242 #size-cells = <0>;
243 compatible = "lantiq,xrx200-mdio";
244
245 phy11: ethernet-phy@11 {
246 reg = <0x11>;
247 compatible = "lantiq,phy22f", "ethernet-phy-ieee802.3-c22";
248 };
249 phy12: ethernet-phy@12 {
250 reg = <0x12>;
251 compatible = "lantiq,phy22f", "ethernet-phy-ieee802.3-c22";
252 };
253 phy13: ethernet-phy@13 {
254 reg = <0x13>;
255 compatible = "lantiq,phy22f", "ethernet-phy-ieee802.3-c22";
256 };
257 phy14: ethernet-phy@14 {
258 reg = <0x14>;
259 compatible = "lantiq,phy22f", "ethernet-phy-ieee802.3-c22";
260 };
261 };
262 };