lantiq: switch from uci-defaults to board.d
[openwrt/openwrt.git] / target / linux / lantiq / patches-3.18 /
2015-11-21 John Crispinlantiq: add phy led config support over devicetree...
2015-11-21 John Crispinlantiq: tweak DWC2 default parameters
2015-10-19 John Crispinlantiq: Print the status register whenever an error...
2015-10-19 John Crispinlantiq: Fixed reading the number of RX FIFOs in the...
2015-10-05 John Crispinlantiq: fix ath_pci_fixup hang on bridged devices
2015-09-14 John Crispinlantiq: Add AR9 compatibility bits to DWC2 driver
2015-09-14 John Crispinlantiq: Initialize USB on AR9 platform
2015-09-11 Felix Fietkaulantiq: Use the BAR0 base address in the ath PCI fixup...
2015-09-02 Jonas Gorskikernel: update 3.18 to 3.18.21
2015-08-17 John Crispinlantiq: Support newer versions of the PEF7071 ethernet...
2015-07-12 Hauke Mehrtenskernel: refresh patches on linux 3.18
2015-07-07 John Crispinlantiq: Silence the printk when a PCIe error interrupt...
2015-07-07 John Crispinlantiq: Change the data-type of mac address in ETOP...
2015-06-30 Jonas Gorskikernel: update 3.18 to 3.18.17
2015-06-17 Jonas Gorskikernel: update 3.18 to 3.18.16
2015-06-05 John Crispinlantiq: Backport gpio-stp-xway to fix the highest bits...
2015-05-23 John Crispinlantiq: Fix initialization of the PCI IRQs when PCIe...
2015-05-23 John Crispinlantiq: Fix PCIe bus when PCI is also enabled.
2015-05-21 Jonas Gorskikernel: update 3.18 to 3.18.14
2015-05-03 Imre KalozThe ability to read MAC addresses from MTD is useful...
2015-03-15 Felix Fietkaulantiq: add a better fix to strip FCS from ethernet...
2015-03-11 John Crispinkenrel: refresh patches
2015-03-11 John Crispinlantiq: make the new dwc2 support only work for vr9
2015-03-11 John Crispinlantiq: Use platform endianness when accessing dwc2...
2015-03-11 John Crispinlantiq: Add sensible hw-defaults for dwc2
2015-03-11 John Crispinlantiq: Configure gpio power output pin when initializi...
2015-03-11 John Crispinlantiq: Add usb initialization bits from ltq-hcd to...
2015-02-14 John Crispinlantiq: disable buffered writes on Intel command set...
2015-02-14 John Crispinlantiq: Fix flash for targets with NO_XIP
2015-02-12 John Crispinlantiq: make m25p80 work again
2015-02-12 John Crispinlantiq: fix mac addr assignment inside lantiq_etop
2015-02-09 John Crispinlantiq: add 3.18 support